200RD Multi-Fold Door Hardware

Step 1. Order Track to Desired Length

In standard applications track is usually ordered in lengths that at least equal the overall opening width. Johnson Hardware recommends that single track lengths be used whenever possible to avoid door hangers passing over track splices during operation. Track splicing is acceptable only if hanger wheels DO NOT pass over the splice. If multiple track lengths are to be used in a single opening, ensure that track and door panels are positioned so that no door hanger/guide passed over track splice. Track mounting screws not included with track, screws are included with Base Set A part sets.

Step 2. Order Base Set A

Base Hardware Set A contains all the pivots, brackets, hangers and mounting screws to hang the 1st pair of panels from a single jamb. Order base hardware set A (2015BS-A) for the first pair of panels off jamb as indicated. Order 1 base set A when all panels operate from a single direction. Order 2 base sets A's when panels will operate from two directions, converging panels that meet in the middle of the opening. NOTE: Panel hinges are NOT included in Base Set A Hardware Sets. Johnson Hardware offers ball bearing mortise hinges in standard finishes that meet the maximum panel weight below. If you use other hinges, consult hinge manufacturer for weight limitations.

Step 3. Order Add-On Set B

Order one add-on hardware set B (2002PLBG) for every pair of panels after Base Set A as indicated. NOTE: Panel hinges are NOT included in Base Set B Hardware Sets. Johnson Hardware offers ball bearing mortise hinges in standard finishes that meet the maximum panel weight below. If you use other hinges, consult hinge manufacturer for weight limitations.